|
|
|
Utica-Rome Vic 200 Rules Revisions Announced |
|
05/04/08 -
Vernon, NY- With the Dart Machinery Victoria 200 set to go on May 11, Utica-Rome Speedway management has released the rules for the $10,000 to win event. Additions or revisions are noted with an asterisk.
The rules will follow the 358-Modified Utica-Rome Speedway rulebook with the following exceptions:
361 cubic inch or less-2,400 lbs. (gas only)
Big Diamond/Grandview Small Blocks- maximum 750 carburetor- 2,400 lbs. (alcohol allowed, per track rules)
Big Blocks- 2,500 lbs.
*Cast iron blocks only- NO Aluminum blocks.
No tolerances on weight, must make weight after qualifying and main event.
No fuel injection.
Sail panels allowed- Total Height is to be measured from ground to the highest point, not to exceed 65. Total length is to be measured from of rear axle, 48 from the center line to rear of car and 12 from center line forward. Maximum vertical lips will be 2 from door up and 2 from door down. The degree of angle from vertical lips (upper and lower) to rear plane of drivers seat is 22 degrees. Sail panels must have same dimensions on both sides of car.
*4 inch maximum roof spoiler allowed.
Tires- Any 92x 13 Dirt Modified tire, including American Racer, Hoosier, or Goodyear. No Late Model tires.
One way radios and transponders are mandatory.
For more information regarding rules, please contact Lloyd Larmon at (315) 767-7819 or by email at llarmon@frontiernet.net. All other information is available at www.uticaromespeedway.com or by calling the speedway office at (315) 829-4557.
|
|
